Instant Access Registration Takes Less Than 15 Seconds! You May Not Post Until Registered.
To start viewing messages, select the forum that you want to visit from the selection below.
If you are having trouble staying logged in when navigating between forums/topics/etc., you need to reset your session cookie. Go into your browser and delete any cookie for the site them log back in. This should fix the login issue.
The only caveat to that would be if you have a certain vial that contains 20 IU or another certain vial that contains eight. But most have 10 and I'm sure that's what you meant. And depending on what you have some vials need to be vented some don't. Certain ones if you vent them the powder goes everywhere because they're not made of good solid pucks and I believe because there's negative pressure in the vials. My verbiage maybe slightly wrong but I've had vials where I did and did not have to vent them. You probably already know this and I'm not trying to insult your intelligence I just know I feel like I screwed up quite a few vials early on.
When drawing out there was alot of suction so i must need to do that then.
My dam bac water amps once their open i cant close the top, WTF thats ridiculous.. I guess ill find a lid that i can secure down on top of it
yup use a small needle like a 25 gauge or smaller and pin it in slowly on the side of the rubber stopper... don't let the needle stab the puck and only insert it far enough to release the air because if you use enough BW it can go up and out the venting needle if pushed in too far. I always used a bit more than one ML when reconstituting because you waste less gh overall when some gets stuck in the hub of the needle. When inserting the needle for the BW remember to tilt the vial and slowly inject and let the water drip down the side... don't spray directly/ aggressively onto the gh. Think guns uses a bit of a different technique that sounded legit when he explained it to me.... forgot though.
Alright sounds good, yea i watched a few vids on youtube and i got the method down right. I think im gonna use a 29gear pin so theres not so much pressure like when you use a slin needle.
Alright sounds good, yea i watched a few vids on youtube and i got the method down right. I think im gonna use a 29gear pin so theres not so much pressure like when you use a slin needle.
i just pull the pluger out of the back of a slin pin and put it in to vent myself.
Yeh that method is def less complicated. No idea why I've been doing it my way this past year other than the fact that that's how I was told to do it. LOL
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment