Announcement

Collapse
No announcement yet.

heating gear before use?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Re: heating gear before use?

    I used the microwave to heat my prop for 20 seconds and had no problem. I was also using b12 and injecting it with the prop. I nuked both of them together for 20 seconds and the vile of b12 exploded after only 10 seconds but the prop was fine thank God. Different substances will react differently and gear is pretty expesive so I wouldn't recommend microwaving it. Just go with the hot water bath or the hair dryer and be careful. Don't make the same mistake I did.

    Comment


    • #17
      Re: heating gear before use?

      Is it fine if you use a hair dryer..on your syringe ?? to heat the shit up..

      I used to roll the syringe in my hands for about 2 mins until it gets warmer.. no pain..

      Comment


      • #18
        Re: heating gear before use?

        yeah i do it too if its not warm enough from the vial. it should hurt the pin, but if it get too warm u can shrink the syringe and the plunger will be hard to push in a few spot. that could lead to a bad experiance. just dont over do it and melt the plastic.
        Badasz1@Hushmail.com

        Comment


        • #19
          Re: heating gear before use?

          I remember the first time I went to the doc and he nuked my shot
          "God grant me the serenity to accept the things I cannot change...Courage and Strength to change the things I can...And Wisdom to know the difference."

          Comment


          • #20
            Re: heating gear before use?

            the micro is quick and easy, and it won't hurt the gear in under 30 seconds . Dazed recomends the micro to put powder into solution.

            Comment

            Working...
            X