Announcement

Collapse
No announcement yet.

heating gear before use?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • heating gear before use?

    Hey fellas, I have been nuking my gear (QV enthanate) for 8 seconds to thin it out so it wont hurt after injection. It works like a charm, no pain whatsoever. My question is: Is nuking it degrading the gear? Is it making it weaker,?

  • #2
    Re: heating gear before use?

    some say it does, others done care. a warm water bath is usually enough. load your syringe, then run it under hot water for a few minutes. nuking can cause damage to the rubber stopper and aluminum cover.

    Comment


    • #3
      Re: heating gear before use?

      You can also put in on your coffe maker base (with the coffe pot removed) and turn on your coffee maker to warm the base plate.

      Comment


      • #4
        Re: heating gear before use?

        I used to put a coffee cup full of water in the microwave and warm it up for 1 minute. Then Id drop the vial I was using at the time in the hot water, let it sit for about 2 minutes then pull it out of the vial. When the oil is warm it injects and dipurses through the muscle easier.

        Comment


        • #5
          Re: heating gear before use?

          just hot water 4 me


          ATTITUDES ARE CONTAGIOUS, MINE MIGHT KILL YOU!

          "Goals are Dreams with Deadlines!"

          Note: All of my advice and posts are merely for educational purposes I do not condone the use of steroids or any other illegal drugs. I am no doctor and my advice should be taken with a grain of salt, just like everyone else's hypothetical advice.

          Comment


          • #6
            Re: heating gear before use?

            Boiling water seems to do the trick for me. Place vial in a dish, add boiling water. Let sit for a couple minutes. Your set.

            IG

            Comment


            • #7
              Re: heating gear before use?

              Originally posted by Iron_Gook
              Boiling water seems to do the trick for me. Place vial in a dish, add boiling water. Let sit for a couple minutes. Your set.

              IG
              Boiling!? Trying to burn your ass?

              Comment


              • #8
                Re: heating gear before use?

                I NEVER DONE IT..I will try it when i start my enathate 250 50 ml jug

                Comment


                • #9
                  Re: heating gear before use?

                  i nuke mine for 20sec.

                  Comment


                  • #10
                    Re: heating gear before use?

                    the juice no blowup?

                    Comment


                    • #11
                      Re: heating gear before use?

                      if you nuke yours, (i dont) remember to take the pin off or you will blow up the microwave!


                      ATTITUDES ARE CONTAGIOUS, MINE MIGHT KILL YOU!

                      "Goals are Dreams with Deadlines!"

                      Note: All of my advice and posts are merely for educational purposes I do not condone the use of steroids or any other illegal drugs. I am no doctor and my advice should be taken with a grain of salt, just like everyone else's hypothetical advice.

                      Comment


                      • #12
                        Re: heating gear before use?

                        Originally posted by BIG_MIKE1979
                        I NEVER DONE IT..I will try it when i start my enathate 250 50 ml jug
                        I've never done it either. I am using QV Test E 50ml right now and I don't get why people say it hurts. I am on my 10th week now and have yet to have a sore spot from it. I guess I'm just lucky. Or the rest of you guys are just girls!!! Just joking!!!!!!
                        "I came. I saw. I conquered!!"

                        Comment


                        • #13
                          Re: heating gear before use?

                          Use a hair dryer,...put the vials against a wall, face the hair dryer towards the vials and blast away for 2 minutes...Works like a charm....
                          Obsessed is a word used by the lazy to describe the dedicated..

                          Comment


                          • #14
                            Re: heating gear before use?

                            hair dyer works great but if a solution crashes due to cold microwave it, i usually nuke my vials for 25 seconds before injecting. by the time i draw and get ready to stick the solution is still warm.
                            Badasz1@Hushmail.com

                            Comment


                            • #15
                              Re: heating gear before use?

                              Well, Im on my third week now and definitely feel the gear kicking in. I know the gear is not being degraded because when I use a gram a week of test my forehead will get really oily throughout the day. In the past I have used 500-700 mgs a week of test and never had the oily forehaed so it is a go on nuking your gear.
                              Keep in mind I only nuke the preloaded syringe with out the needle part and not the vial or jug.


                              Later fellas

                              Comment

                              Working...
                              X