Tweet2

TweetGET RID OF THAT EXHAUST SAP,LOL

Tweetand the bracket. I cut pieces of that plastic/rubberish sleeve that they use over the factory wires to length and slid it over the new wiring for added protection. I pulled the wires tight back up into the trunk with the rest of the factory wiring and zip-tied it off the best and neatest way I saw fit. The '08 trunk, and the way they ran the wires is a little different than the '07, It's the same wiring, just some extra plastic. They added wiring holders to help keep the wires more stationary as well as a full plastic casing along the bottom and up the sides of the trunk (it's all one piece)...so even by removing the factory plastic that covered the hole for the wires on the outside, it has the bottom of that 'trunk liner' to cover that hole from the inside.

Tweet

Originally Posted by FUZO

GET RID OF THAT EXHAUST SAP,LOL

You need my address? I need the mid-pipe first...it's pretty inexpensive. Then I'm probably going with yoshi just for sound. The Yoshi bikes just sound so good on the track. Reminds me of my CBR...that ching chong chang shyt on the symbol sucks, but they produce such a badass distinct sound. But if you're adamant about the 2-brothers, I'll accept your givings,lol.

Tweetsweet man can you get me one from directly under the bike so i can see how you attached the black piece that holds the tag to the other piece once again thanks man

TweetWHY NOT JUST GET AN INTEGRATED TAILLIGHT AND GET RID OF THE BLINKERS ALL TOGETHER?

https://clearalternatives.com/Merchan...tegory_Code=R6

Tweeti would love to and i will soon but i just don't have 130 extra bucks right now

TweetI DONT KNOW HORSE THE 2 BROTHERS SOUNDS KICK ASS ALSO

Tweet

Originally Posted by FUZO

I DONT KNOW HORSE THE 2 BROTHERS SOUNDS KICK ASS ALSO

I know man. I'm sure that'll be what will end up on my bike. They look good too.

Tweet

Originally Posted by O2BESOHUGE

WHY NOT JUST GET AN INTEGRATED TAILLIGHT AND GET RID OF THE BLINKERS ALL TOGETHER?

https://clearalternatives.com/Merchan...tegory_Code=R6

That is definitely the way to go. You know I don't dig anything hanging off the bike, e.g. blinkers and shyt. I almost went that route but my main concern with riding more on the street is people noticing my rear signals so I just went with those because they're hard to miss. I know the integrated tail-light signals are on point as well, I just worry about the one idiot that wouldn't notice it. That is the best looking way to go though. I'm just a worry wart about the rears.

Tweet

Originally Posted by jamescb77

sweet man can you get me one from directly under the bike so i can see how you attached the black piece that holds the tag to the other piece once again thanks man

that black piece is one of the metal pieces that hold those red reflectors off the sides of the factory tag thing...ya know the ones I'm talking about? There's one on each side. I just cut one in half. Bent it 90 degrees, and as you see, used the screw for the reflector to bolt the tag on with. The other end that's under the bracket is held in place by the bracket itself. There's no need to attach it any kind of way. When you tighten down the bracket, it ain't going no-where. It's tightened down between the undertail and the bracket.

Tweet...but yes, I will get one shooting directly up at it so you can see that. 'a picture's worth a thousand words.'

Tweetu got ya sounds good man thanks a lot