from amp to pin??

[tinytim]

ok so im using test250/cyp its in a 2cc amp

is there anything wrong with me just pulling out the plunger and dumping it in the pin....it takes forever for me to get it all out sucking through the 25g needle?

[Dark Stalker]

Use a 18g to draw the oil, then switch to your favourite needle size for inject

[BossDJ02]

Originally posted by Dark Stalker
Use a 18g to draw the oil, then switch to your favourite needle size for inject

thats what i do

[tinytim]

good iedas guys but right now im stuck with all 25g ....i think i can get a 18 soon tho

[medium1]

It's a little tricky because some will squirt out when you put the plunger back in.

[tinytim]

yea ..im also having trouble geting air out of the 25g with out loosing to much oil any hints???

[MYRICK]

go to walmart and get some 18's also when u clear the air dont blo it out the needle i usually just push until i see the gear get to the pin that little bit of air isnt going to hurt u

[JohnnyB]

Gat an 18g Bro

JohnnyB

[Dark Stalker]

good iedas guys but right now im stuck with all 25g ....i think i can get a 18 soon tho

You might heat up your gear a little bit.. It helps to draw the oil, basically you put some medium hot water into a container and put your amp in it for a few minutes, I did that with my sust a while back, worked great with 22g.