Am i retarded abotu warming up my oil?

[LOCO]

i have done it once.... and didn't see any difference..... aaand i've never done it again... cold is just as good and easy....

[Alpine]

Originally posted by GSU7
The best thing to do imo is to heat bowl of water and put the vial/amp in the water and then into the syringe that way sterility is not compromised. Just my .02.

Thats what I do.....

Just makes it a bit quicker/easier to draw + it stays a lil warmer going in.

[O2BESOHUGE]

MY WATER IN MY BATHROOM SINK IS SO HOT I JUST RUN THE WHOLE SYRINGE UNDER IT BEFORE I INJECT IT. THEN UN CAP IT AND INJECT WITH NO PROBLEM.

THAT WORKS FOR ME.
O2

[bowbow]

Originally posted by BigD
I run the capped syringe under hot water, but I make sure never to let the water touch the cap itself, I keep it flowing over the barrel of the syringe. So far, I've never had any probs, and I can get any oil I want through I 28g slin pin

That is what I do also.

[superchicken]

water takes so long, just nuke it for 5-10 secs. easiest, fastest, and no water gets anywhere you dont want it to

[newbie]

I use a heat lamp. It only takes like 3 mins and does not compromise the sterility of the needle.

[TxLonghorn]

I just run hot water over the syringe. I would feel a little weird about microwaving my gear. That sounds like gear abuse, lol.

[rado]

I've never run my gear under anything, I just shoot up as is. oh well.

[Drenten]

I take my car out for a spin and get the turbos nice and hot, then I use a set of tongs to hold the syringe over the turbo for a couple of minutes, then I inject.

Seriously, even using a 25-gauge needle, it takes all of 5 seconds to inject oil at room temperature…but whatever.

[##spiderbaby##]

Originally posted by TxLonghorn
I just run hot water over the syringe. I would feel a little weird about microwaving my gear. That sounds like gear abuse, lol.

Same, just run it under the hot water tap. I have never had or heard of anyone that has recieved and infection from a little tap water on the needle.

Sometimes I think we can get to carried away with sterility. Not that it is awful, we all know that and ounce of prevention... blah blah blah, but still water is not going to hurt you.

[football54]

I just load the shit take a shower and shoot when I get out. My muscle is warm and I've never had a problem. I have never warmed up any of my gear.

[EQLgearstud]

i've never warmed my stuff yet.....

[superchicken]

Originally posted by ##spiderbaby##


Sometimes I think we can get to carried away with sterility. Not that it is awful, we all know that and ounce of prevention... blah blah blah, but still water is not going to hurt you.

i agree, we do wash our cuts and wounds in tap water dont we? lol

but its always good to be cautious, you never know what you might get inside you.

[Nytol]

I boil some water, put it in a cup, place the amp in the water and leave it for 10 mins. With sustanon it definatly cuts down on next day soreness and makes it easier to inject.

[prolangtum]

I heat it just for the fact that it seems to "spread out" over the muscle a little better, so the pain isnt centered in one spot.