Announcement

Collapse
No announcement yet.

Sterilizing Gear

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Sterilizing Gear

    There has been alot of discussions regarding abscesses and the prevention of. One possible cause of an abscess is bacteria in the gear itself. I know you can heat gear when it becomes crystalized.

    Couldn't you heat gear to remove most of the bacteria? If so, how do you do this?

    Thanks

  • #2
    Re: Sterilizing Gear

    THE BENZYL ALCOHOL THATS IN THE GEAR SHOULD BE ENOUGH TO KILL BACTERIA...THERE ARE OTHER FACTORS THAT CAN MAKE IT UNSTERILE. EVERYTIME YOU TOUCH THE TOP OF THE VIAL YOU MAKE IT UNSTERILE. THAT COULD GET ON THE NEEDLE AND THEN WHEN YOU PUT THE NEEDLE INTO THE VIAL TO DRAW IT OUT - YOU JUST CONTAMINATED THE WHOLE VIAL. WIPE EVERYTHING DOWN WITH ALCOHOL TO TAKE EVERY PRECAUTION YOU CAN TO KEEP THINGS STERILE. BUT EVEN THATS A SLIM CHANCE IT WILL HAPPEN.

    I HAVE USED BOTH PHARM GEAR AND HOME MADE OR UNDERGROUND GEAR OVER THE YEARS AND NEVER ONCE HAD AN ABCESS. IVE HAD SOME SHOTS THAT HAVE MADE THE AREA RED AND IT HAS GOTTEN SWOLLEN AND CAUSED A LOW GRADE FEVER. BUT NOTHING TAKING SOME ADVIL DIDNT TAKE CARE OF.

    YOU GUYS ARE JUST JUMPING THE GUN ON THE ABCESSES A BIT

    O2
    ..“Your desire to change must be greater than your desire to stay the same.”





    Comment


    • #3
      Re: Sterilizing Gear

      I agree with O2...I feel my swollen, red hot, third ass cheeks have come from me moving my pin around to much at the injection site.

      Comment


      • #4
        Re: Sterilizing Gear

        i as you guys have had swollen cheeks for a while but again, nothing that advil didn't take care of. Just curious if even those swollen cheeks could have been prevented

        Comment


        • #5
          Re: Sterilizing Gear

          Would it be ok to inject some more Benzyl alcohol into the gear...just to be sure or would that make the gear worse?
          22yrs old, 5'7", 185Lbs, 12%BF, 16.5" Biceps, 4 Pack.

          Goal = 190Lbs, 5%BF, 20" Biceps, 6 Pack.

          Comment


          • #6
            Re: Sterilizing Gear

            rto much BA makes for VERY painful injects. You might get away with just a tad, but then I would put a pin in the top and re-bake it( on a cookie sheet in the oven @325 for 15min at a time for 3 times- then take it out and pull the pin)

            Comment


            • #7
              Re: Sterilizing Gear

              Originally posted by JohnSours View Post
              Would it be ok to inject some more Benzyl alcohol into the gear...just to be sure or would that make the gear worse?


              dont shoot any more into it unless you want to limp
              Disclaimer: Steroid use is illegal in a vast number of countries around the world. This is not without reason. Steroids should only be used when prescribed by your doctor and under close supervision. Steroid use is not to be taken lightly and we do not in any way endorse or approve of illegal drug use. The information is provided on the same basis as all the other information on this site, as informational/entertainment value.

              Please take the time to read these threads!

              Fitness Geared Shoutbox rules

              FG member signature rules

              Fitness Geared Forum Rules

              http://www.fitnessgeared.com/forum/f334/

              http://www.fitnessgeared.com/forum/f283/

              https://www.tgbsupplements.com/

              Comment


              • #8
                Re: Sterilizing Gear

                k so no more benzul but i wouldn't mind baking it, i will actually need to, to get the crystals out but 2 things:

                1) will the vial break if i put it in the over for the amount and temp Deep said to put it at?

                2) I was told that baking makes the compound/bonds of the gear weaker and hence makes them less effective. any truth to that?
                22yrs old, 5'7", 185Lbs, 12%BF, 16.5" Biceps, 4 Pack.

                Goal = 190Lbs, 5%BF, 20" Biceps, 6 Pack.

                Comment


                • #9
                  Re: Sterilizing Gear

                  Originally posted by JohnSours View Post
                  k so no more benzul but i wouldn't mind baking it, i will actually need to, to get the crystals out but 2 things:

                  1) will the vial break if i put it in the over for the amount and temp Deep said to put it at?

                  2) I was told that baking makes the compound/bonds of the gear weaker and hence makes them less effective. any truth to that?


                  Ive never ever seen any solid proof about baking gear and losing dosage but what I did was use the microwave for 10 seconds at a time to see if the crystals go away. Ive done it before and they went away and ive shot it and I still grew.try boiling it in water first. boil the water then stick the vial in there and let it sit. If that doesnt do it try the microwave for 10 seconds then continue until gone
                  Disclaimer: Steroid use is illegal in a vast number of countries around the world. This is not without reason. Steroids should only be used when prescribed by your doctor and under close supervision. Steroid use is not to be taken lightly and we do not in any way endorse or approve of illegal drug use. The information is provided on the same basis as all the other information on this site, as informational/entertainment value.

                  Please take the time to read these threads!

                  Fitness Geared Shoutbox rules

                  FG member signature rules

                  Fitness Geared Forum Rules

                  http://www.fitnessgeared.com/forum/f334/

                  http://www.fitnessgeared.com/forum/f283/

                  https://www.tgbsupplements.com/

                  Comment


                  • #10
                    Re: Sterilizing Gear

                    Originally posted by JohnSours View Post
                    Would it be ok to inject some more Benzyl alcohol into the gear...just to be sure or would that make the gear worse?

                    SSHHHHHIIIIIITTT NO!! ADDING MORE BA WILL CAUSE IT TO HURT MORE!
                    IT IF HURTS TO INJECT ITS PROBABLY GOT TOO MUCH BA IN IT
                    ..“Your desire to change must be greater than your desire to stay the same.”





                    Comment


                    • #11
                      Re: Sterilizing Gear

                      IF IT WERE ME...I WOULD ADD 1 ML OF BB TO IT AND REHEAT IT.

                      BENZYL BENZOATE IS PAINLESS TO INJECT AND IT WILL KEEP IT FROM CRASHING MAKING MORE CRYSTALS
                      ..“Your desire to change must be greater than your desire to stay the same.”





                      Comment


                      • #12
                        Re: Sterilizing Gear

                        Thank you much guys.

                        Will have to find BB first.

                        Then will try the boiling water.

                        Than Nucking it.

                        Hopefully it will go away.
                        22yrs old, 5'7", 185Lbs, 12%BF, 16.5" Biceps, 4 Pack.

                        Goal = 190Lbs, 5%BF, 20" Biceps, 6 Pack.

                        Comment


                        • #13
                          Re: Sterilizing Gear

                          good info. thanks guys

                          Comment


                          • #14
                            Re: Sterilizing Gear

                            im with o2. here lately people have really been jumping the abscess band wagon. there are people that get abcesses but if you keep your stuff clean it should next to never happen. You also will no without a doubt you have an abscess and you will know it within 24 hours. add a little BB to it if it's getting crystals, heat it in some water and enjoy. Personally i think baking is a waste of time and energy but you can do it.

                            Comment

                            Working...
                            X