Eql Tren/prop Pain!!!!!

[teutonic]

Is this ok?

I boiled a pot of water. When water was boiled I turned off the gas and put a piece of tin foil over the pot. I then poked a bunch of holes in the tin foil and placed the syringe/drawing needle with the juice in the syringe(obviously) on top of the tin foil. I let it sit there for 20 minutes and let the steam rise up and heat it. It thined it out pretty good. I then switched needles and injected into the Tricep. It went ok but I sure can feel where I injected.

One thing is that it looked like it left droplets of water in syringe but that could only have come from the steam. So is this OK?

By the way I ordered the sterile oil.

[pigmeat]

why go to all the trouble? put the cap back on the pin after drawing, hold on to caped needle holding syringe upside down, and run a small stream oftap water over the syringe.I dont see how you could get water inside doing it like this

[gearedup]

If something is painful then you want to shoot it into a bigger muscle if you are injecting into your delt and you hit the outer part or inject more than 1ml of something of that strength this fast acting then you should expect it to hurt! Also moving it around while in you can make it worse! Try the glutes and if you need to warm it up before injection! Also most people say it ius very little pain I am with you on not liking pain and I took a shot of it and it hurt a little bit but I also took it in the delt!

It will get better and be pain free when you add another steroid such as EQ or a sterile oil it will be painless! One of my closest friends is on it and sayd it is absolutely painless to him even though I felt it a little but I am more sensitive to injection pain!

Also the muscles you are injecting this to like you just mentioned the triceps is crazy and I would expect it to hurt I think you are crazy for that shit man I would never inject that high mg/ml of tren/prop into a tricep!

Sorry I didnt see a reply to the thread I missed the question you had until now!

[teutonic]

I'm injecting 1/2cc

Hey geared than where would you recommend injecting. I'm doing ED injects. You mention Glutes (thats 2 shots) where else do you recommend shooting.

I ordered sterile oil last night

[pigmeat]

glutes, quads. At .5cc you may get by with only these. If not hit delts also. I agree with geared. Tricep,chest, bicep injections are crazy what you shooting.