my bud had a jug of oil he needed to sterilize...got the .2 Whatman.while filtering into a 50ml jug, the pin slipped out a couple times, he put it back in and kept going...when the first 25cc's was done, he left the filter in the jug and refilled the other 25cc then reattached and began filtering again..pin slipped out again a couple times....so when he finished, he baked at 250 for 20 min. w/ a 22g pin to vent...after 20 min...the plastic from the pin is melted, the pin is still there of course...so he cools it off and theres some baked on plastic residue and a tiny hole where the pin was..so the rubber has a tiny hole in it exposing it to air...
he says fine, as long as it was baked and filtered..i say no way cause the hole in the top...is this normal?
he says fine, as long as it was baked and filtered..i say no way cause the hole in the top...is this normal?
Comment