Instant Access Registration Takes Less Than 15 Seconds! You May Not Post Until Registered.
To start viewing messages, select the forum that you want to visit from the selection below.
If you are having trouble staying logged in when navigating between forums/topics/etc., you need to reset your session cookie. Go into your browser and delete any cookie for the site them log back in. This should fix the login issue.
I was reading some threads over at Steroidology and a thought came to mind. Most vets say the first few cycles are the best; I belive this is due to the recptors having very little gear experience so they respond better. Also, a lot of newbies want to cut and build at the same time.....well I do too. But its not that practicle, so i thought since the first few cycles r the best (i am currently half way into my first) that the best way is to just bulk as much as possible and far down the road worry about cutts. What do u bros think?
I wanted to use clen after PCT because i can't during, since everyone says its catabolic and not anti-catabolic , but if my thoughts were correct in my earlier post shouldn't i just worry about bulking till i am content (or at least close) to where i want to be size-wise and not worry about cuts?
Some people can cut and gain at the same time without much effort and then some have a hell of a time trying to do that....everybodys body is different and what works for one might not for another....most vets gained their knowledge by trial and error and by putting to use the information they've gathered so its hard to give a definitive answer on how to cut and gain at the same time but i think in general it is easier to gain then cut and not try and do it all at once. good luck bro
i think it all depends on goals. if you are lean and smaller then bulk as much as you can until you get to the size you want, then lean out. some people start out fat and want to lose that first... its very different for everyone
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment