Making Tren..need advice

[califitness]

Just made 6g of tren and i need advice. Should I sterilze it??? I don't want it to hurt my tren. If so, How long and at what temp, What do you guys think. I think i was careful but i never really know. I know i don't want an infections. Thanks

[Muscleguy40oz]

You sterilize it by putting the vial in boiling water for 15 mins and then let it cool and repeat 3 times...Make sure you vent the vial with a syring needle...Put the vial in while the water is warming up so the glass doesnt break...I have never sterilized it and never got an infection of any sort.. You wont hurt the tren in any way...

Muscleguy

[Derek]

no need to boil. The BA content in your final yeild makes it safe. As long as you used a somewhat clean enviroment and conversion process.

chem...

[califitness]

thanks guys

[koss]

Im always a freakin slob so I feel like Im injecting sludge unless I cook it. 20 min at 250 degrees in the oven. I even do it to my premade gear.

[LOCO]

[Quote]

"If you desire to sterilize your final product and it is highly recommend, Bake it for 250 degrees for 15 min then let cool and repeat 2 more times. 250 degrees is not enough to melt the stopper. (Some advocate putting a pin in the stopper to let air escape, but being careful not to stick the pin in so far that your liquid spurts out as it heats.) This process is not to evaporate alcohol but heating and cooling 3 times is to kill bacteria. The boiling point for BA is over 400f, so your right, baking wont remove it. Also keep in mind that the BA(ie magic solution) is what allows us to suspend 75mg+ per ML and without it we risk having the tren/AAS precipitate and sit on the bottom of the vial. "

http://www.gotfina.com/articles/make.html

[DangerousGround]

BS I just take whole rubber top off use 100 cc vial bake 1 time 250 degrees for an hr or so.
Its not needed but easily done and seems to make better IMO. I don't like idea of putting hot rubber topper and pins to vent. It vents much better without any top.

I made many batches no problems not baking so if hard to sneak i would avoid. I have easy access, lol.

[DangerousGround]

Originally posted by Muscleguy40oz
You sterilize it by putting the vial in boiling water for 15 mins and then let it cool and repeat 3 times...Make sure you vent the vial with a syring needle...Put the vial in while the water is warming up so the glass doesnt break...I have never sterilized it and never got an infection of any sort.. You wont hurt the tren in any way...

Muscleguy

dry heat from baking in oven is better for sterilizing bro.