high mg/ml and pin size

[BODY]

will I have trouble pushing 400mg/ml through 25x1? was wondering if I should change size on my order. I only shoot quads and bicep.

[hardscience]

bump for a good question

[MUCH BIGGER]

What kind of trouble were you having?
I used 25x1 with 400mg/ml oils and had no problems. Higher concentrations are a bit thicker it seems. I warm up the oil to about 96 degrees and inject slow. 1cc takes about a min for me. You just can't shoot it in like water based products.

[jack hust]

you should not have a prob. you might be trying to go to fast just take your time 1 -1.3 min per cc in high mg-ml

[iamdwalrus]

Higher concentrations are usually more viscous, just a matter of warming it up.

[Disposable_Hero]

what are you injecting?

D_H

[bluesmalone]

I have no idea what gauge my pinz are..all i know is they say 1.2mm.. and they're pretty fucking huge and sometimes a little painful..anyone know what gauge that is?

[guntruck]

Originally posted by iamdwalrus
Higher concentrations are usually more viscous, just a matter of warming it up.

My thoughts exactly, I have used 25 g pinz b4 with no probs. I would heat it up some if its harder than usual as stated above.

[BODY]

THANKS GUYS. i HAVENT GOTTEN ORDER YET JUST THINKING AHEAD. sorry for caps. it's gonna be EQ but you gave me great info, I'll be injecting slowly it seems so I wont have to ask later -"WTF is going on". will stick w/ 25x1. you guys r great THX

[gearedup]

I can push my 400mg EQ through a 25 guage! Thats just me though I seem to hold special talents over everyone! j/k lol!

[Billy_Bathgate]

Ive pushed Supra T425 through a 25g many times with no trouble. It will flow through a 27 even. Ive used tren through a 29 and 30 as well. The plunger can make quite a bit of pressure.

[BODY]

knowledge is power ! keep shouting my friends

[pigmeat]

shoot all of my gear through 25g pins.currently 400mg test,400mg eq, no problem. Run the syringe under hot tap water for a min or 2 before shooting. 25g = no pain!