Prop through 27g?

[Mudge]

I'm looking to do prop, but with EOD injections and 500mg/ml, I'm either going to need to thin it out (which means alot of oil in the body) or find a way to more accurately measure doses before injection. Since slin pins dont detach from the pusher, what do I do?

Should I give up and thin it out? Or will I be able to heat up the pin a little (in 170º or so water in a baggy) and be able to inject it? Or is there a 1cc pusher SOMEWHERE out there with a 25g pin or a detachable one?

[BIG-G]

just use 25g heads on regular 3cc syringes bro. Why the complications. If ur going for an acurate measurement then get syringes with iu markings on em .

[CJWolf]

500 mg/ml prop?

ouch

but i put it through slin pins all the time ...

[jack hust]

damn what brand prop is that

[rado]

Originally posted by CJWolf
500 mg/ml prop?

ouch

but i put it through slin pins all the time ...

yea no shit...ouch...

[Drenten]

Dilute the injection with bacteriostatic water at the time of the injection. It will take the pain out of the injection and you will not get a big build up of oil.

If the propionate you have is 500mg/ml and you want to do 250mg EOD you would draw a half of a ml of the propionate into the syringe and a half a ml of bacteriostatic water. Obviously, the oil and water won’t mix, but it will work to eliminate the pain.

Also, you can get a 30g .5” Luer-Lok needle, so there is really no need to mess around with insulin needles.

[Lmg2701]

never heard of prop being in that concentration but for it to be possible it would hurt like a mofo with the high alcohol content......who is it made by?
you can do like drenten said or just order some sterile oil .75 sterile oil and .25 of the prop you have and just shot 1cc in 2 different places, it would get to be a lot of injections but it's one way to go.

[Mudge]

Its UG stuff, thier EQ and prop are both 500mg/ml. 250mg EOD would put me at 875mg a week, way more than I want to do. The pushers I have are marked in increments of 5 per every CC, so while I could get a semi-accurate 1/2cc I am asking for something a little closer to perfect.

30g? Wow, that sounds really iffy, even 25g is a little bit rough with enan, but not so bad especially if warmed up. I know the difference between 23/25 is noticeable so I wasn't sure 27g was doable. If anyone knows where I can get 3cc stuff in markings of 10 for the first CC that would be nifty, or I'll just break down and dilute it out with some sterile oil.

Basically I would like accuracy as well as avoiding lots of oil buildup.