Pins Where Can I Shoot?

[Gymjock]

Hey bros.

I have 21g 1.5" pins

I'm gonna run a 300mg Deca 400mg Test cycle for 8 weeks

Questions:

1) Can I use these pins on quads & glutes?

2) Is 3.5cc to much to inject into glutes & quads?

3) Can I rotate just quads and glutes only? (2 shots a week)

Thanks bros Gymjock

[Skarn]

Hey bro,

Yeah, you can use them, but 21g are too big for me. I use 25g 1" pins in glutes and thighs. Also you don't have to rotate both glutes and thighs for 2 shots a week, you can do just glutes, or just thighs. Get some smaller pins, less scar tissue and they are so easy to get. Look at the thread about trusted friends for some good people.

Good luck,
Skarn

[Skarn]

Oh yeah, and 3.5 cc? How you gonna do that? Most syringes only hold 3cc's. I shoot 3cc's in glutes and quads with no problem. 3.5 cc's each time would require more than 2 shots a week...

[Gymjock]

Hey bros I have 5cc syringes so shooting 3.5cc isn't a problem. I've just recieved some 22g 1.25" pins can I use these to shoot in thequads?

Thanks, GymJock

[jack hust]

i only use 25ga 1inch and 5/8

[arms2]

The smallest Pin I ever used was 23g It took forever and a day to draw the oil out off the bottle and it took forever to push the oil in my ass, but this is test. Enat. I'm talking about. I just can't see how you bros use 25g. I guess you must heat the gear to make It thinner ????? But I have so much scar tissue I guess I'm going to try some. Now I'm useing and have been for years only 22g 1" and 1.5 pins.

[bufflildude]

draw the oil out with 18g then switch to the 25g.

buff

[Skarn]

Originally posted by arms2
The smallest Pin I ever used was 23g It took forever and a day to draw the oil out off the bottle and it took forever to push the oil in my ass, but this is test. Enat. I'm talking about. I just can't see how you bros use 25g. I guess you must heat the gear to make It thinner ????? But I have so much scar tissue I guess I'm going to try some. Now I'm useing and have been for years only 22g 1" and 1.5 pins.

I use 25g 1" for test enth, EQ, and Fina. I draw with an 18g or 20g pin then switch to the 25g. I have no problems pushing it in. It takes longer, but I like that.

[WkBRdR]

draw with low #s and shoot with high #s that works the best...

[BigE22]

I use 23g 1" for quads....and 22g 1 1/2" for gluttes.....

[LOCO]

i use 23-25g 1.5in for everything... for my 1st cycle i used 21g 1.5in and did quads/bis/tris/delts... quads 3cc's max, bis/tris/delts 2cc's max

[LOCO]

no.. 3/4 of the needle.... i always leave a bit sticking out..

[jsjs24]

I wouldn't do any more than 3cc in one shot, that would ball up and hurt like a ***** imo.

[jsjs24]

Originally posted by LOCO
no.. 3/4 of the needle.... i always leave a bit sticking out..

I do too with 1.5s.

[teddyk]

3.5 cc is definitely too much. I once put 3cc in my ass and couldn't walk for a week.