TweetMostly fom the second draw, first one is ez...
TweetI am having one hell of a time getting the exact doses I need from each. You guys have any pointers or tricks you'd like to share?
TweetNot really any tricks.. just draw your more important oils first. Second one, I draw and measure from the middle of the barrel. Say I draw 1ml of Test and then want 1ml of Tren. Draw the Test.. then when drawing the Tren, I'll put the top of the Test at the 2ml mark and measure my tren from 2 down to 1ml tick on the syringe.
TweetOkay, I'll try that next. Pretty sure I just pinned a cc of tren and test though, lol! Off to the gym now!
Tweetyou could always try and back load. i think pitts idea is EZer though
TweetI pull 1ml of one oil and then pull the syringe back while thumping it getting all the oil out of the neddle. Then I insert it into the other vial then push the syring up putting air into that vial. Then I pull back to the 2 mark. You should have 1ml of each this way. I have had no issues and I have done this for years.
Tweetthe tip of the needle is going to hold about .1 ml in it so first oil draw down to .9 ml than pull it out. Now bring the plunger down to the 2ml mark and the oil should go right to 1ml mark, leaving 1ml of air in the top. bring it back up to the top than than draw out the next vial to 1.9ml. pull it out and bring the plunger down to 3ml mark and it should fill right to the 1ml mark giving an even 2ml
TweetJust add more
For ed pinning i back load. Its mostly for the time constraints. On Sunday I'll sit down and load up all my pins and vitamin containers for the week.
TweetI do this often also.. especially for ED pinning. I'll do at least 3 days at a time or so. Saves a few drawing pins as well.
TweetI just go over a bit every time. My 2.5 ml's usually ends up being 3 ml's.
TweetLOL. Why not right? haha..
Tweet^^^EXACTLY!^^^
TweetMy 1.75ml's is ending up around 2.3ml's! Thanks for the tips though, I'll get this figured out one day, or just keep pinning more then I want. LOL!
Tweetwipe off both tops with alcohol swab
draw the amount of air for both vials into syringe
put appropriate amount of air into each vial
draw out amount from each vial
change needle
enjoy
Tweet
This has been my method for decades and have never had any issues.