TweetHahah What did you expect DRVJ ? LOL 175mg/ml of which is made up of a compound that doesnt like to go about 100mg/ml plus another that doesnt like to go up must past 150mg/ml while still being relatively painless? A depot just is not going to be stable at that high of concentration. When does it hurt? Right after you inject, or about 36hrs down the road, or worse..both?
Here are my thoughts of what I would do:
1) There is probally a shitload of solvent in there to get it that high. Not nessicarily all BA though, but I would suspect it is high as well. I would want to lower this down some.
2) You need to dilute that shit down, to like half should be good.
So from these things, add equal amount of oil to dilute. The alcohol concentration will be 1/2 of what it was...so it may be fine now and you can just leave it at that. If it was really high to start with, inject a little sterile water, maybe 3ml at a time, shake it all up and then let it sit till the layers have seperated. Suck the water back out and discard. This will remove soem BA if its still too hight.