Melanotan FAQ/Guidebook - Melanocyte

[956Vette]

TweetMelanotan II (MT-2)

MT-2 is a fairly new biotech polypeptide and there is no other substance in the world that will increase melanin (skin pigment) production in humans. This is the only substance that will actually induce a tan in people. You DO NOT need any UV exposure to tan with MT-2, but it does expedite the process.

Melanotan I & II – from wikipedia, are analogs of the peptide hormone alpha-melanocyte stimulating hormone (α-MSH) that tend to induce skin tanning and, in the case of melanotan II, increase libido.
Both drugs were developed at the University of Arizona. Researchers there knew that one of the best defenses against skin cancer was a natural tan which has been slowly developed over weeks. They hypothesized that an effective way to reduce skin cancer rates in people would be to induce the body's natural tanning system to produce a protective tan prior to UV exposure. They knew the body's naturally occurring hormone alpha-melanocyte stimulating hormone (α-MSH) caused melanogenesis, a process by which the skin's tanning cells (melanocytes) produce the skin's tanning pigment (melanin). With that knowledge they tested to see if administering this hormone to the body directly could be an effective method to cause sunless tanning. What they found was that while it appeared to work, natural alpha-MSH had too short a half life in the body to be practical as a drug. So they decided to try and find a more potent and stable alternative, one that would be more practical.
After synthesizing and screening hundreds of molecules, the researchers headed by Dr. Victor Hruby, found a peptide that after trials and testing seemed to not only be safe but also approximately 1,000 times more potent than natural α-MSH. They dubbed this new peptide Melanotan. Since their discovery, numerous studies dating back to the mid-1980s have shown no obvious toxic effects of Melanotan. Because skin cancer (melanoma) today is a major health concern, Melanotan is expected to be used as a drug to combat it. Melanotan will do this by stimulating the body's natural tanning mechanism to create a tan without first needing exposure to harmful levels of UV radiation. This in turn will reduce the potential for skin damage that can eventually lead to skin cancer.

Melanotan I

Melanotan has the amino acid sequence Ac-Ser-Tyr-Ser-Nle-Glu-His-D-Phe-Arg-Trp-Gly-Lys-Pro-Val-NH2 or [Nle4, D-Phe7]-alpha-MSH. Melanotan is currently being tested and developed under the name CUV1647 by the Australian company Clinuvel Pharmaceuticals, for indications such as Polymorphous Light Eruption (PMLE) and Actinic Keratosis (AK).

Melanotan II

Melanotan II has aphrodisiac properties. It is a cyclic lactam analog of alpha-MSH with the amino acid sequence Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2. Palatin Technologies of New Jersey has developed another hormone targeted towards Sexual dysfunction based upon melanontan II which they call Bremelanotide (formerly called PT-141). Bremelanotide is a metabolite of melanotan II that lacks the C-terminal amide function. Bremelanotide is currently in clinical trials to treat erectile dysfunction and sexual arousal disorder.

How it works:

MT-2 is a chemical analogue of a something the body naturally produces
called alpha-Melanocyte Stimulating Hormone (a-MSH). A-MSH is what induces skin cells called melanocytes to produce melanin -- the pigment that tans a person's skin and is responsible for the various colors of skin around the world in humans.

MT-2 out competes a-MSH for binding to melanocyte receptors in humans and other mammals because it has a binding affinity over 1000x more potent than
a-MSH. Therefore only milligrams are needed to do what would normally take lots of a-MSH to do.

When you are exposed to UV rays (whether tanning bed or sunshine) your body produces more a-MSH, hence the eventual tan. However, genetically pale people fall into one of two categories. They either do not sufficiently produce enough a-MSH, or their melanocytes have a weak affinity for a-MSH.

MT-2 overcomes both of these limitations. Anybody can get as dark as they like with MT-2, it is simply a matter of dosage - the more the darker you will get. The tan is 100 % real, so it fades as slowly as a real tan once you stop using (3-4 weeks average).

The only people MT-2 will not work for is pure albinos -- they're melanocyte receptors have zero affinity, thus even MT-2 simply cannot bind and hence they have no skin pigmentation. MT-2 will work unequivocally for everyone else, even very pale redheads can get very dark.

How it is used:

You need to be properly informed in the storing and usage of peptides
-- they denature rapidly if you mishandle them.

If you order 30 mg (which is a sufficient amount for a first-time beginner cycle) you will receive your 30 mg of "lyophilized" (it means
"freeze-dried") MT-2.

Put two vials in the freezer (deep freeze if you have one) -- DO NOT
RECONSTITUTE (reconstitute just means "mix" with bacteriostatic water) these vials. Just freeze them as is.

Then with the vial you are going to be using, reconstitute (mix with
bacteriostatic water).

To mix the vial with bact water, take one of the syringes (BD Ultrafine II 1cc or 1/3 cc are excellent and I recommend them) and grab your bacteriostatic water. If using a 1 cc syringe (100 units) use the syringe to withdraw 1 full ml (1cc) and inject that into the vial of MT-2 through the rubber. Be sure to aim the needle towards the glass, so that it will trickle down. Swirl the vial to thoroughly mix and let the peptide dissolve.

So now you have 100 units (1cc) of bacteriostatic water mixed with 10 mg of MT-2 in your vial.

Then inject roughly 100 units (1 cc) of air into the vial so that the vial is not a vacuum -- otherwise withdrawing peptide will be tricky because of suction in the vial. Don't inject too much air into the vial; otherwise the air pressure will push too much air back into the syringe when you try to withdraw the peptide for injection. Around 100 units usually works fine -- the "units" I'm using as a ref. for injecting are on the side of the syringes (100 unit = one full syringe).

Now, that the vial is mixed (reconstituted), when you withdraw 10 units of the substance, that equals 1 mg of MT-2. So 30 units would equal 3 mg, get the idea?

Now you're ready for subcutaneous injection. If you've never performed sub-q injection before, it's very simple, and if done right, you literally don't feel anything. The needles used for sub-q injection are extremely small (8 mm) and you only go in 5 mm or so -- just into fatty tissue beneath skin. NOT intravenous or intramuscular this is a bit more complicated. Certain diabetics perform sub-q injections with the same tiny needles you'll be using two-three times a day.

You can use the same syringe you used to add the bacteriostatic water to the vial for your first injection. But never use the same syringe twice on yourself -- this is a universal rule no matter what you're injecting. Syringes and bacteriostatic water are extremely cheap and you can get them with ease.

You will store the reconstituted (mixed) vial in your fridge -- NOT your freezer like the others.

I recommend 1 mg of MT-2 per day for the first week or so. One morning injection, or one in the evening, it is up to you. Remember, you will experience some nausea most likely for the first couple days. Listen to your body. It's nothing to be alarmed about, it's perfectly normal. Your body is simply finding a new homeostasis as it acclimates to the peptide in your blood. Your body adjusts within 2-4 days at the latest and you will never have any nausea again -- unless you come off MT-2 for a long time (over 2 months) and then resume heavy dosing. So remember, the nausea is COMPLETELY normal and entirely goes away. The harder and more frequent erections as a side effect however will persist for as long as you are taking MT-2. MT-2 is more powerful than Viagra in this regard, and that is why we are interested in the analogue version of MT-2 called PT-141 to treat ED as well!

After a week of 1 mg per day dosing you can play with the dose until desired shade of tan is achieved. From there, maintenance dosing is minimal. I usually just use 1 vial over 10 days and then take 2-3 weeks off completely, and then repeat.

Remember, the lyophilized MT-2 (freeze dried) will last in your freezer for 1 year. But once mixed with bact water, the MT-2 will degrade. YOU MUST STORE THE RECONSTITUTED MT-2 in the REFRIGERATOR -- NOT freezer. Also, there is no magic pill or formula here. Trial and error are critical to learning. Share your melanotan experience so that our research continues to prosper!

How do I get Melanotan: Melanotan.org

[FUZO]

TweetGOOD POST

[TestRip7]

TweetVery informative.

[IloveDeadLifts]

TweetHow long will the reconstituted Melanotan II last in your fridge? And if not wanting to come off what would be a typical maintenance dosing protocol?

[956Vette]

Tweet

How long will the reconstituted Melanotan II last in your fridge? And if not wanting to come off what would be a typical maintenance dosing protocol?

Should last 6 weeks or so. Some report longer, some shorter.

.5mg every 3-4 days is typical maintenance dose

[IloveDeadLifts]

TweetThanks, looking forward to seeing how dark I can get. I'm pretty fair but I can normally hold a tan going to a bed 2x week so I think I should get some god results from this stuff.

[956Vette]

Tweet

Thanks, looking forward to seeing how dark I can get. I'm pretty fair but I can normally hold a tan going to a bed 2x week so I think I should get some god results from this stuff.

Great! also metachems.com supports FG and should take care of members from here. Been using peptides from them myself

[firstenrgy]

TweetI did reconstitute MT-2 and then froze it. 4 weeks later I put it back in the fridge and it worked just as well. I wouldn't reccomend doing so but I got called away on business... well monkey business but anyway I froze it and it still worked.

[956Vette]

Tweet

I did reconstitute MT-2 and then froze it. 4 weeks later I put it back in the fridge and it worked just as well. I wouldn't reccomend doing so but I got called away on business... well monkey business but anyway I froze it and it still worked.

Good to know, thanks for sharing that. A lot of bed wetters claim they do this and ruin the peptide. Of course poorly managed forums run wild with this....

[Testify]

TweetThanks for posting this vette. It is an interesting new product for us, and for more than one reason. Anyone else with experience using MT-2? I'd like to hear your opinions of the peptide and how you ran it.

Question: is the effect on libido & erections a result of MT-2's influence on blood pressure (promoting blood vessel dialation like most other ED drugs), or does it somehow effect the baseline testosterone levels - or something else entirely? Thanks again vette.

[FROGMAN]

Tweeti've got a couple of things to say about MT-2. First it works. Works fast and if juice was this good we all would be 295 and 4% bf. I've used it now for about 2 years and two things happen. I get super dark. Even almost black after 2-3 months taking 1mg a day 5 days a week and only laying in a bronzer bed for 10 minutes 4-5 times a week. Second, talk about chubby's. GEEZUS. Great stuff. Now that I've used it quite a bit I can tell when either a batch is really good or just ok. Maybe it cooked in the sun to long enroute but even then still works. My buddy owns a tanning salon and everyone wonders how i get so dark so fast. I started going a week ago and it looks like i've been tanning for 6 months. Even better, when I go to Brasil I totally fit in with the natives especially since I speak portuguese and everyone thinks I'm a carioca(rio native). I love this stuff and so does my girl. best shiznit out there IMO

[Testify]

TweetVette - and anyone else - I remember reading about MT-2 about a year ago, when it was newly discovered/created. I think I remember that the peptide has lipolytic properties as well as the ones stated above - is that true? If so, to what extent is it effective for burning fat?

[956Vette]

Tweet

Vette - and anyone else - I remember reading about MT-2 about a year ago, when it was newly discovered/created. I think I remember that the peptide has lipolytic properties as well as the ones stated above - is that true? If so, to what extent is it effective for burning fat?

Ive been using melanotan since 2005 and it does not have any fat burning properties. It may curb your appetite depending on how and when you dose...but it can be avoided

[daved150]

Tweethuh...i'm pretty intrested in this. who am i kiding, i'm pretty intrested in everything !!! lol