Tweetboiled the juice itself or let it sit in hot water?
too much heat cna damage the hormone...
TweetBOILED MY CYP AND IT CLEARED IT UP SO FAR, LETTING IT SIT FOR A COUPLE HOURS THEN I WILL CHECK. AND BOILING DOES WHAT AGAIN TO IT
Disclaimer: Steroid use is illegal in a vast number of countries around the world. This is not without reason. Steroids should only be used when prescribed by your doctor and under close supervision. Steroid use is not to be taken lightly and we do not in any way endorse or approve of illegal drug use. The information is provided on the same basis as all the other information on this site, as informational/entertainment value.
Please take the time to read these threads!
Fitness Geared Shoutbox rules
FG member signature rules
Fitness Geared Forum Rules
https://www.fitnessgeared.com/forum/f334/
https://www.fitnessgeared.com/forum/f283/
https://www.tgbsupplements.com/
Tweetboiled the juice itself or let it sit in hot water?
too much heat cna damage the hormone...
TweetYEAH DONT BOIL IT JUST GET IT HOT
TweetI JUST BOILED THE WATER THEN I USED SOME PRONGS AND HELD IT IN THERE FOR A MINUTE AT A TIME UNTIL THE CLOUDINESS WENT AWAY
Disclaimer: Steroid use is illegal in a vast number of countries around the world. This is not without reason. Steroids should only be used when prescribed by your doctor and under close supervision. Steroid use is not to be taken lightly and we do not in any way endorse or approve of illegal drug use. The information is provided on the same basis as all the other information on this site, as informational/entertainment value.
Please take the time to read these threads!
Fitness Geared Shoutbox rules
FG member signature rules
Fitness Geared Forum Rules
https://www.fitnessgeared.com/forum/f334/
https://www.fitnessgeared.com/forum/f283/
https://www.tgbsupplements.com/
TweetThat should work then. I thought you boiuled your oil at first..figured your gear was now shot..lol. All you were accomplishing was getting the hormone back into solution. You are good to go now bro. In the future, I suggest sticking an 18 gauge pin in the stopper before doing that, just so any build up in pressure can vent.
MOD at www.legalgear.com
Yes, I am a part of Legalgear, so I could be biased in some issues