how about this cutting cycle guys...

[BullFX]

TweetI dont wana use Tren so here is what i came up with:

1-12 eq 400mg /wk
4-12 prop 525mg ed
8-12 winstrol 50mg ed

i thought i should run eq earlier than test since it takes it a long time to kick in any way, i dont wana be shut down on test for too long, so i figured by wk 4 eq has kicked in and shut me down when i add prop (def shut down) to the equation. does that make sence?

also what do u think of the doses? too high? too low? my last bulker was 750mg of sust and 600 deca . but this one is going to be a cutting cycle . wana go from 15% to under 8%.


Thanks

::BULLFX::

[digital]

Tweeti would run the prop from week 1(but then again my cycles are 9 mnths:p )

dosages look fine but i would run test till week 14 till eq clears,and run winny from week 9-14

so imho,
week 1-14 test prop
week 1-12 eq
week 9-14 winny 50mg ed
clen 2 weeks on 2 off if you want with eca inbetween.

clomid/nolva pct and on hand.

my 2cents

[BullFX]

Tweetthats the thing i dont wana stay on too long though ... i wana be shut down max of 8-10 wks so i gues i could go

1-12 eq
4-14 prop

[digital]

Tweeti here ya,

but eq shuts you down hard to,some say as much as deca,maybe running a shorter cycle will be of more benefit to you whereby you would drop eq for something that works quicker?

e.g
week 1-6 test prop
week 1-6 winny 50mg ed

pct

[Gear101]

Tweetthonk you'd be better off runing the eq to ten and the prop to week 14.. then no eq woulsd be wasted

[Madmax]

Tweetbro start the prop from the begginging of your cycle. theres no reason you should start it at week 4...why not add some masteron in there...hows this, might be a little expensive but its a better cutting cycle than the one above...MM

prop 75mg ed (1-12)
masteron 50mg ed (7-12)
var 40mg ed (7-12)
primo 400mg (1-10)

[BullFX]

Tweetthanks felllas ,

hey MM i like that cycle but as you said it is a bit more pricy ... i can do prop and masteron or prop and var or prop and primo but not all 3 ...

[orion76]

TweetEQ is basically test anyway so just run the prop from the start.