Makin test from powder question.

[DrtyJrzyGuy]

TweetOk, all i have access to is powder products, so i ahve decided on test eth at 500mg a week for 10 weeks. . . simple and effective i figure. My qestion is what is the best way to make an injection. I have come across several ways, I am curious if there is a general opinion as to wwhich is the best way. Also, what size pins should I order?I was goign to go with 25g. is this to small? thanks.

I was planning on using research kits powder kit, is this a good idea? Should I get the products on my own seperatly? thanks again guys!

[Got Gear?]

TweetHmmm... make an injection?


I'm guessing your looking for help on finding how and where to inject?

There is a spot injections subforum with some good info. Or try www.spotinjections.com

[Blackfoot]

TweetWhat do you mean "make an injection?" Are you asking how to convert the powder or how and where to inject? And, I like 23g they get it in quicker.

[DrtyJrzyGuy]

Tweetok, I wasn't very clear at all. I am making test from a powder. I am looking to convert it so I can inject it. Which is the best way to do that. I have come across a few methods which all seem to be the same more or less with a few differences, I am curious if there is a way which is better than the otehrs or if it si more personal preference. The thing I am most concerned about is that no bacteria at all gets into my end product.

[Stupid Biotch]

TweetGo to this link. It's from our "Conversions/kits" forum. Obviously you didn't see that one lol...no biggie.

https://www.fitnessgeared.com/forum/s...threadid=19440

This is very detailed. You'll get the jist of it all. Here's how I do it. For enanthate...since that's what you'll be using.

Take 10g of enanthate powder and dump it into a 40ml screw top vial (you can get those at www.researchkits.com). Add the required amount of Benzyl Alcohol (I like to use 1.5-2ml) Then fill up the 40ml vial till the top (just below where it starts to round) with oil. Then shake it up good...throw it in the oven at 250 for about ten minutes....shake it up again...and leave it in the oven for another 10 min.

now suck it out and pass through a syringe filter into a sterile and sealed vial.
Then you have 40ml of 250mg/ml test enanthate.

You can buy the sterile oil..syringe filter...40ml screw top vial...and sterile sealed vials at www.researchkits.com.

Check out that link above like I said...it's very detailed.
Good luck.

[Stupid Biotch]

Tweetoh......another thing....you could probably just get a kit from researchkits.com if you wanted to. And order an extra 40ml screw top vial just in case they don't give you one with the kit.
So just order a 4gF kit and an extra 40ml screw top vial and you're set.

I use 23g 1.5" pins for my glutes so get those.

[BossDJ02]

Tweet

Originally posted by Stupid Biotch
oh......another thing....you could probably just get a kit from researchkits.com if you wanted to. And order an extra 40ml screw top vial just in case they don't give you one with the kit.
So just order a 4gF kit and an extra 40ml screw top vial and you're set.

I use 23g 1.5" pins for my glutes so get those.

exactly what i did. its way cheaper.