30g 1/2"

[Sage]

TweetIm wanting to do a chest inject and asking what the highest number gauge one could/should use. Also, we probably wanting atleast 5/8-1" but locally, ive been able to only find 1/2". This is strictly for chest since im fine with other areas with my 25g 1" pins. Much appreciated
Sage

[jack hust]

Tweeti use 25 ga 5/8 on the pecs but if you can get what ever your inj threw a 30 ga more power to ya

[6p6]

TweetI can never seem to be able to get stuff out of a 30g once it's injected into the site? more power to you if it works....

[Drenten]

TweetPushing an oil based steroid through a 30g would be a workout in itself so you would be killing two birds with one stone.

Think of it - forearm workout/spot injection.

Seriously though, I think that the half-inch will be fine if you are reasonably lean, as long as you can get whatever you’re injecting through a 30g – that’s going to be the trick.

[Sage]

TweetSounds like it would be quite a challenge. I was hoping someone who has used a 30g needle, to chime in. Anyone?
Sage

[flexer01]

Tweet30 is too small. It wont work unless its water based.

I use 30g for tricep injects. but i had water based suspension.

[Stupid Biotch]

TweetI've chest injected with a slin pin. No problems. Just heat it up a little.

[srfchsr]

TweetI've chest shot QV 50mg Winny with a 28 1/2 gauge slin pin for a few weeks last cycle. I tried with 29 guage pins but they got clogged a little. btw I didn't notice any real benefit to site injecting winny.