need some opinions !!!

[34pumped]

Tweetok i been injecting in my quads 2 1/2 cc of gear. when i start to inject no pain until i get about 1 3/4 to 2 cc in my quad then it hurts bad.. so today when it started hurting i pullled out and injected in another spot and put the last 1/2 cc in..and no pain at all...any ideas on wtf is going on?


im using qv cyp and supradeca

[darmadoc]

TweetMy guess would be that the last 1/2 cc really causes pressure in the muscle and that's when it starts to hurt. I had the same problem, and found that slowing the injection down helped alot. Hope that helps.

[34pumped]

Tweetummmmmmmm ok bro next time i ll try that thanks!!!!

[njjuicer]

Tweetmy guess is u keep doin it right abotut eh same are amke sure u move that shit around

[njjuicer]

Tweetbye the way 34 u *****

[sAiNt4LifE]

Tweeti had the same problem 1cc prop 1cc fina and 1/2 cc of oil.... i found that i wasn't going slow enough.......i slowed down and no problems at all....

[Lmg2701]

TweetPut a heating pad on your leg before you shoot and warm up the syringe under some hot water, inject slowly and you should be fine.

[rado]

Tweetnever had that problem, you rotating 34....maybe you should give that site a rest

[34pumped]

Tweetyea bro i rotate but im gonna do glutes for the next 2 weeks

[fragmaster3sum]

TweetHAD THE SAME PROB M8 IN DELTS...IF YOU PRESS A FINGER INTO ANY INJECT SITE IT WILL HURT SO IMAGINE A BUILD UP OF FLUID INSIDE THERE TRYING TO PRESS "OUT" IT MAKES SENSE TO SLOW DOWN I SUM TIMES TAKE 30 SECS TO DELIVER THE GOODS... AND IT GIVES THE JUICE TIME TO DISPERSE RATHER THAN BUILD UP AND CREATE PRESSURE.. A LITTLE BIT OF CARE AND MORE TIME SAVES 48 HOURS OF PAIN... AND ALSO YOU SHOULD REMEMBER THAT IF YOU PULL THE PIN OUT HALF WAY THROUGH THE DELIVERY YOU SHOULD CHANGE FOR A NEW STERILE PIN!!