How to convert long r3 IGF-1 Powder?

[Muscleguy40oz]

TweetCan anyone give me info on how to convert the powder into injectable form? I appreciate the help...

Muscleguy

[Josh]

Tweeti was told you just add the BA depending on your supplier...

[Harvey Balboner]

TweetYep from everything I've read at Animals board, he was saying just to put it in BA.

I will be doing this to in a month or two. Be sure to post your results.

[Muscleguy40oz]

TweetWell i will be getting 1 mg to do a cycle at 25mcgs/day for 50 days... How much ba would you use on 1 mg? Do you add any sterile water to it? Thanks

Muscleguy

[machine99]

Tweetposted by L.A. over at musclechemistry, but this is with liquid igf not powder, but since yuou haven't received your igf yet and it might be liquid hope this healps.

I do IM injects but to prepare it here's an easy way.

It comes in 1000mcg per ml.

Take 2 ml of of bacteriostatic water water an add it to the vial it came with. Now you have 1000mcg per 3 ml.

Take 2 slin pins and fill them from the vial. Each pin holds 1ml. Freeze these pins. Each pin will have 333mcg in them and there will be 333mcg left in vial.

Add 2 more ml of of bacteriostatic water to what's remaining in the vial. This gives you 333mcg in 3 ml or approx 100mcg per ml. Now you can use a slin pin to measure out the amount. 30mcg would be 30 on a slin pin, 40 would be 40 and so on.

When you run out, take one of the frozen pins and add it to an empty vial. Add 2 ml of of bacteriostatic water and you have the same solution as before (333mcg in 3 ml or approx 100mcg per ml).

I do mine 5on/2off at 30mcg for 4 weeks. So I end going through 2/3 of a 1000mcg a cycle. So for every 2000mg purchased I get 3 cycles worth.

[Muscleguy40oz]

TweetThats some good info machine...I will be getting it in powder form and was planning on adding 1 ml of BA and 1 ml of sterile water...So if im correct 5 ius on a slin pin will be 25 mcgs of IGF... Is this correct?

Muscleguy