odd stuff in test e

[dirtwarrior]

TweetI just finished this vial of test e and in the bottom was a small amount of what looked like gel. None others did this. What was it?

[MOUNTAIN-MAN]

TweetThat does sound strange Maby it crashed?

[sofargone561]

TweetHHmm thats weird. I had tren that had a cloudy mushy gelly like compound in the bottom so i threw them out. I really dont know. Test E doesnt crash to easily from my experiance. Test e can be brewed with just BA and BB so i dont see how or why there would be anything else in it.

[mikeyg51]

Tweetmine had something similar once and i think it crashed...the cold plane transport really f*cked some of the vials up!

But gel is odd...i will look that up brother...I don't know much about that...mine was more crystalized

[sofargone561]

TweetExactly ^ usually crashed gear till turn into crystals. Im not chemist so gel is totaly possible but usually its crystals from my experiance so im just as stuck as everyone else.

[dirtwarrior]

TweetI think it crashed. So how do I get it to suspend again?

[rocky83]

TweetHeat it up brother. Do you know what kind of oil the test E was suspended in? That could play a big part.

[dirtwarrior]

TweetI did heat it. I boiled water took it off the stove then soaked it over night. All is good now.
Thanks to all who replied

[jandkk24]

TweetIf it crashes again just use a lighter underneath till it dissolves. Don't put the flame on the glass but close enough to heat it. Also put a needle in the stopper so the air has an escape as heat expands shit. Ready to go in a few minutes. Ill usually do this to draw into a slin pin and let it set for a few minutes so its easier to draw in.

[MemphisMax]

TweetMy test cyp I used to get from the pharmacy did this every time. Just heat it up a bit. Nothing to worry about.

[MOUNTAIN-MAN]

TweetGlad u worked it out brother

[animal87]

TweetI've heard of coconut oil geling up if it gets too cold. Thats the only instance I know of.

[rocky83]

Tweet

I've heard of coconut oil geling up if it gets too cold. Thats the only instance I know of.

^^^That's what I was thinking!

[dirtwarrior]

TweetYou know those little hot plates called candle warmers... would they work to keep the test dissolved

[Pittsburgh63]

TweetIt could have been low solvents to begin with, and at the end of the vial perhaps they were somewhat depleted causing it to crash. Heat it up, or try adding a tiny amount of solvent.