Syringes?

[mick-G]

TweetI'm starting my first cycle and I'm using 21 guage 1 1/2 inch needle. My problem is I will aspertate bottle by pushing 3ml air into bottle holding bottle upside down then I will attempt to draw juice, but it will not come up syringe. I have to literally take the stopper end with other hand and pull the stopper back to get juice in the syringe. Even then it is very hard and stopper wants to go back up syringe. When I do accomplish this there is about a quarter air that I have to push out and then redraw to get proper dosage. Am I doing something wrong? Or should I use a larger guage needle?

[Striated]

TweetStrange. 21g should be able to draw up just about everything.

You could drop down to an 18g, 19g, or 20g to see if it works better.

In any event, switch to a 25g before you inject yourself... much easier and less strain on skin and body. It will take a bit longer to inject, but patience (in this case) is a virtue.

[trapattack369]

Tweetwarm up your gear in some hot water

[Jay_Abbays]

Tweet

[i]...... there is about a quarter air that I have to push out and then redraw to get proper dosage. .....[/B]

If you get that much air in it - then your syringe is sifting air. - that might explain why it's not drawing the oil (not enough pressure).

Try changing the syringe.

Jay

PS As trapattack369 said - warm up the oil - it will go easier.

[mick-G]

TweetI will heat up the juice, as I have pushed 3ml air into bottle and needle is in jucie when I draw upside down, but nothing comes up. EQ is Shanghi, Test Cyp. is Testabol Depot from British Dragon. They are both little bit thicker than baby oil?

[ChrisAdams]

TweetYour problem may be that your needles aren't on all the way, so it's drawing air in though where the needle attaches to the syringe.

[bdtr]

TweetYeah man, i can pull anything with a 23 guage 1 inch. Somethings wrong here.

[mick-G]

TweetThey are BD Leur Lok. I tried the heating up thing and it seems to work better, although it is slow in filling up syringe. Thanks for helping. Mick

[flexer01]

Tweetyou might have bunk needles........sometimes the glue they use stops the flow......are all the pins doing it?

[FUZO]

TweetCOULD BE BUNK NEEDLES. IVE USED 25 WITH OIL LITTLE SLOW BUT WORKED

[jipped genes]

Tweeti dont like the bd pins with the screw lock tip. for some reason they flow like crap. it is just slow to draw as long as it goes in and goes out it you will get the job done. next time try monoject or terumo they work well for me.

[mick-G]

TweetThe one I used today on the EQ which seems alittle thicker than the Cyp. flowed after heating in hot water, but was like a quarter ml every 20 seconds. I did get it in, so I guess thats all that counts. I have like hundred needles so I guess I'll use them first before getting something else. I do notice where the pin goes into the syringe there is this white around the needle, where it goes into syringe. Must be the glue?

[jsjs24]

TweetI have never had that problem, and I have used a lot of different pins. Also try to just put the pin in without air in it...that works too. And 20 seconds a 1/4cc, no big deal...at least it's coming up.