learn how to do a wheely

[FUZO]

Tweethttps://www.youtube.com/watch?featur...&v=UhqdYvMadiU

[jipped genes]

Tweetonly time my front wheel comes off the ground is on 100% acceleration if i dont get forward on the bike. but i have never done a wheelie on the street on purpose.

seen too many vids of guys hitting concrete and i am sure that would hurt.

now a dirt bike...........wheelie all day!

[Dzone]

Tweetthats cool. reminds of the first day I had the new dirt bike and tried a wheelie and landed on my face, no helmet...thank god the dirt was soft or I would have been ****ed lol

[Mathom33]

TweetTo make it easier you can do a short throttle mod. If you already have a Dremel you can go to Lowe's and buy a 40 gauge PVC fitting. Cut it the width of the throttle and put it back together. It should shorten the turn close to 72 degrees from 90 degrees. This will increase your acceleration in the fact that you won't have to turn your wrist as much.

I had a 2010 zx10r and that bike was a beast. Doing this mod made it easier to lift the front end, although throttle control through the wheelie is a must.

[rmewrench]

TweetChanging bearing makes it easier to wheelie. I would always go up 4 teeth on the rear sprocket. 100mph wheelies for miles.

Sent from my SCH-I535 using Tapatalk 4

[rmewrench]

TweetGearing.... not bearing..

Sent from my SCH-I535 using Tapatalk 4

[jipped genes]

Tweet

Gearing.... not bearing..

Sent from my SCH-I535 using Tapatalk 4

i have a bigger forged aluminum back sprocket for mine. i have not put it on as it's an ass whipping to change. it is much easier to go with a smaller sprocket in front.

[rmewrench]

TweetRear sprocket change is no big deal at all.. but then again.. I'm a mechanic

Sent from my SCH-I535 using Tapatalk 4

[jipped genes]

Tweet

Rear sprocket change is no big deal at all.. but then again.. I'm a mechanic

Sent from my SCH-I535 using Tapatalk 4

LOL i was a mechanic back when cars had carbs. it's not super hard to change the rear just time consuming. going down a tooth in front is same as up 3 teeth in front about. a buddy went down 1 in front and up 4 in back. his 1st gear is like a tractor

[jipped genes]

Tweet

Rear sprocket change is no big deal at all.. but then again.. I'm a mechanic

Sent from my SCH-I535 using Tapatalk 4

LOL i was a mechanic back when cars had carbs. it's not super hard to change the rear just time consuming. going down a tooth in front is same as up 3 teeth in front about. a buddy went down 1 in front and up 4 in back. his 1st gear is like a tractor