getting last 2 ius

[ByRoN]

Tweetout of the bottle how do you guys do it i have the gen blue tops where i stick the needle there is like a whole that the liquid is suppost to go in can some one explain me a easier way to do this i just ripped the top off and sucked it out like it wass an amp there has to be a better way???

[FUZO]

TweetBYRON YOU DONT HAVE TO TAKE THE TOP OFF.WHEN YOUR DRAWING THE LIQUID AND ITS GOING DOWN PULL THE PIN DOWN ALSO TO THE BOTTOM.YOUR NOT GOING TO GET EVERY LAST DROP BUT SHOULD GET 99% OF IT.AND IS IT UPSIDE DOWN WHEN YOUR DRAWING.PRACTICE MAKES PERFECT

[ByRoN]

Tweetyea its upside down but the way the stopper is it has like a inch long cyclnder that the needle goes in and the liquid has to fall in that then it can be sucked up its not like a vial of aas you know what i mean``

[Stout1]

TweetDon't stick your little needle all the way in

(sure you heard that before, lol)

[mick-G]

TweetFirst stick the 1/2" pin in the rubber stopper, just enough so the pin is sticking out of the stopper, but try to angle the pin so it is kinda in the corner edge of the neck of the vial (the pin doesn't have to be stuck directly in the middle of the stopper), then turn the vial upside down. You should be able to draw out most if not all the solution out of the vial that way. Don't worry if suck up alittle air, you can always push that out later after you draw everything out.

[badasz32]

Tweetwhat mick said.

[NATE]

TweetLOL byron