I just finished this vial of test e and in the bottom was a small amount of what looked like gel. None others did this. What was it?
Printable View
I just finished this vial of test e and in the bottom was a small amount of what looked like gel. None others did this. What was it?
That does sound strange Maby it crashed?
HHmm thats weird. I had tren that had a cloudy mushy gelly like compound in the bottom so i threw them out. I really dont know. Test E doesnt crash to easily from my experiance. Test e can be brewed with just BA and BB so i dont see how or why there would be anything else in it.
mine had something similar once and i think it crashed...the cold plane transport really f*cked some of the vials up!
But gel is odd...i will look that up brother...I don't know much about that...mine was more crystalized
Exactly ^ usually crashed gear till turn into crystals. Im not chemist so gel is totaly possible but usually its crystals from my experiance so im just as stuck as everyone else.
I think it crashed. So how do I get it to suspend again?
Heat it up brother. Do you know what kind of oil the test E was suspended in? That could play a big part.
I did heat it. I boiled water took it off the stove then soaked it over night. All is good now.
Thanks to all who replied
If it crashes again just use a lighter underneath till it dissolves. Don't put the flame on the glass but close enough to heat it. Also put a needle in the stopper so the air has an escape as heat expands shit. Ready to go in a few minutes. Ill usually do this to draw into a slin pin and let it set for a few minutes so its easier to draw in.
My test cyp I used to get from the pharmacy did this every time. Just heat it up a bit. Nothing to worry about.
Glad u worked it out brother
I've heard of coconut oil geling up if it gets too cold. Thats the only instance I know of.
Quote:
Originally Posted by animal87
^^^That's what I was thinking!
You know those little hot plates called candle warmers... would they work to keep the test dissolved
It could have been low solvents to begin with, and at the end of the vial perhaps they were somewhat depleted causing it to crash. Heat it up, or try adding a tiny amount of solvent.
It does do that but it turns white and the same thing happens with olive oilQuote:
Originally Posted by animal87
even if something is crashed cant you heat it on the stove and mix it back up?
I did
I wish I knew howQuote:
Originally Posted by Pittsburgh63
Yeah, if you heated it with no luck add a tiny amount of BB. Shouldn't cause any sting, as that is usually the BA that causes it. You would need a drop or so in there. Then heat it a little and see if it holds.
My man! Good to see you here Pitt!!Quote:
Originally Posted by Pittsburgh63
These solvents can have a fairly easy evaporation rate and if the crimp job isn't air tight, the solvent could very easily evaporate out of the bottle causing the gear to crash much easier, so adding solvent wouldn't hurt, but you may want to re-filter it once you open that vial. That's up to you though brotha.
Thanks brother.... Trying to work up to my come back. Neurology check up in a little bit and I'm hoping to get most if not all my weight restrictions lifted.Quote:
Originally Posted by 6p6
Great to hear my man!Quote:
Originally Posted by Pittsburgh63