Tweet




Try that man and see if it e orks.sumtime the cable sticks in side from bein loose.this vid mite help.i gota 05 636 as well but never had that happen,my friend did on a zx10 last yr.hope that helps man.TGIF!!

Sent from my VS876 using Tapatalk

Tweetoh yea i didnt think about searching youtube. Cool ill check it out!

TweetAhhhh I'm a motorcycle fan! Also mechanic lol

When you crank it up does t automatically rev up or does it idle fine and you actually feel the throttle itself sticking and not recoiling back?

Tweet

Originally Posted by kawa636

Try that man and see if it e orks.sumtime the cable sticks in side from bein loose.this vid mite help.i gota 05 636 as well but never had that happen,my friend did on a zx10 last yr.hope that helps man.TGIF!!

Sent from my VS876 using Tapatalk

This is a good vid. This should help if your throttle is actually sticking and not just idling up.

Wd-40 would not help anyway, if your throttle handle/grip was actually causing it to stick it would most likely be due to debris in which case you would just clean it off. If your problem is it idling up then you have other issues but I'm guessing this isn't your issue.

Also check out stuntlife.com haven't been on there since my bike accident but it's a good site.

TweetWhen I turn the bike on it idles just fine. Its just when I rev it and take my hand off of the throttle itll rev up and sometimes stick at 3k rpm or itll slowly come back down.

This started after sitting for a month so i just found that weird, never had a problem before. I thought it might be the humidity.

TweetOk have you replaced your grips or removed them at all recently? I'm asking because you may have installed the throttle side just a bit to close and is rubbing on the housing.

If not you may have developed a tps issue (throttle position sensor) or throttle body is gunked up in which case clean it.

Or get some of this https://www.ezglidercablelube.com shoot it into your throttle cables to lube them up.


As a side note I would check and make sure you cables don't look damaged on the outside at all, if by chance 1 got to close to something hot it may have started to melt in which case this could cause your problem and you'll need to replace.