Tweetthat is correct hick 1ml of bac water for using the 40iu mark for 4iu of gh
TweetI am trying to mix my bac water with my growth.
The slin pins i have are 0.5ml - so i need to put in 1ml total in the vial right?
So then when i draw out do i pull 40 units for 4IU? or do i have to double it since i dont have 1ml pins?
Im confused.
Tweetthat is correct hick 1ml of bac water for using the 40iu mark for 4iu of gh
TGBSupplements REP
https://www.tgbsupplements.com/
Use code 'Baby1' for $5 off your order
Tweetthank you guns I just wanted to make sure
TweetThe only caveat to that would be if you have a certain vial that contains 20 IU or another certain vial that contains eight. But most have 10 and I'm sure that's what you meant. And depending on what you have some vials need to be vented some don't. Certain ones if you vent them the powder goes everywhere because they're not made of good solid pucks and I believe because there's negative pressure in the vials. My verbiage maybe slightly wrong but I've had vials where I did and did not have to vent them. You probably already know this and I'm not trying to insult your intelligence I just know I feel like I screwed up quite a few vials early on.
Last edited by gusto77; 06-26-2015 at 04:10 PM.
TweetWhen drawing out there was alot of suction so i must need to do that then.
My dam bac water amps once their open i cant close the top, WTF thats ridiculous.. I guess ill find a lid that i can secure down on top of it
Tweetyup use a small needle like a 25 gauge or smaller and pin it in slowly on the side of the rubber stopper... don't let the needle stab the puck and only insert it far enough to release the air because if you use enough BW it can go up and out the venting needle if pushed in too far. I always used a bit more than one ML when reconstituting because you waste less gh overall when some gets stuck in the hub of the needle. When inserting the needle for the BW remember to tilt the vial and slowly inject and let the water drip down the side... don't spray directly/ aggressively onto the gh. Think guns uses a bit of a different technique that sounded legit when he explained it to me.... forgot though.
TweetAlright sounds good, yea i watched a few vids on youtube and i got the method down right. I think im gonna use a 29gear pin so theres not so much pressure like when you use a slin needle.
Tweeti just pull the pluger out of the back of a slin pin and put it in to vent myself.
TGBSupplements REP
https://www.tgbsupplements.com/
Use code 'Baby1' for $5 off your order
Tweetok sounds good Gunz brah!
TweetYeh that method is def less complicated. No idea why I've been doing it my way this past year other than the fact that that's how I was told to do it. LOL