21 guage?

[TRAM]

Tweeti was looking at doing 50mg/ed of winny from sydgroup @ 6wks. i read that a 21 guage has to be used because of the particle size. i wanted to hit my shoulders left right left right... is this gauge to big to do this here. within reason. sounds painful eod in the same spot. i would as well be rotating glutes to thighs w/ my test & eq. so thats why i wanted to stay in the shoulders w/ the winny. what gauges are needed w/ the test qv & the sydgroup eq.

[HungarianBeast]

Tweetoils, I go with a 25 gauge. It takes a little longer to push it though. I use 23g 1.5 on the glutes though.

[DIRTY_SOUTH]

TweetDo some more research bro, First of all you don't need a pin that big for winny! Second of all it can be taken orally and you'll only lose about 3-7% on oral absorption so save the injects for your oil based gear.

[DangerousGround]

TweetI like 23 ga 21ga is a harpoon!

[DangerousGround]

TweetI personally rather inject winny be careful all is sterile water-based (gets bacteria easy) can cause abscess if not sterile real easy...

[FUZO]

TweetDRAW WITH A 21 BUT DONT USE IT FOR SHOOTING.THIS IS WHAT I USE
22G-GLUTES
23G-QUADS
25G-DELTS
I AGREE WITH HB MIGHT TAKE A LIITLE LONGER TO PUSH BUT ITS NO HARPOON

[TRAM]

Tweetthanks for the shish-ka-bob prevention, i'll get back.

[jenergy]

Tweet22g, 23g, 25g - for oil-based steroids, 27g, 29g - for insulin, HCG, HGH, and some water-based steroids. 21g-25g for some lower quality types of winny or suspension, higher quality versions can use a smaller needle generally. 22g and 23g are fine for glutes and quads. 25g is preferred for the smaller muscles such as delts, biceps, triceps, etc.

[pigmeat]

TweetI use 25 gauge for everything. I have pushed 400mg test, 400 mg eq, and anything else you can imagine through them with no trouble. Lot less scar tissue with the 25 gauge, and it forces you to go slow, which helps with the pain

[mama-c]

Tweetwhen im spot injecting winny its my bi's and tri's i use a 25 gauge syringe with a 5/8" needle and when i inject i apply a little more pressure to make sure i inject deep enough. It may sound crazy but i have also injected same place with the same size pin for masteron.

any other areas glute, thighs i use 22 gauge syringe with a 1 1/2" needle. Im sorry but I love injections and love the feel of the needles, its a pure rush for me. sorry i get off on it. LOL

[Heywood Jablome]

TweetI use a 20's to draw and 25's to shoot all oils. If it doesn't flow through a 25 I won't use it. I've hit DP***m's water based winny through a 27 doing spot injections in to my chest, tri's, bi's, traps, and delts. No pain, the bigger the needle the more likely you are to damage your muscle. As long as it flows at a steady rate my advice is to use the highest possible guage pin.

[newone1]

TweetDepending on BF - you can use 29G slin pins. Draw with a second syringe from vial. Pull the plunger on the slin pin, back fill, replace plunger, remove air bubbles. You can generate some major presure with a 1cc slin syringe so you'll get the gear out....but you would never be able to draw, you must preload. I do use 22G for quads and gluts.

[O2BESOHUGE]

Tweet

Do some more research bro, First of all you don't need a pin that big for winny! Second of all it can be taken orally and you'll only lose about 3-7% on oral absorption so save the injects for your oil based gear.

DIRTY HIT THIS ONE ON THE HEAD!! BELIEVE ME, YOU WILL REGRET USING THE 21 GA. FOR FREQUENT SHOTS!!

O2

[lxorl]

Tweetdrink it!!

[bgpittbull81]

TweetDO NOT STICK A 21G PIN IN UR SHOULD..OH GOOD GOD YOU WILL BE HURTING BRO..TRUST ME...25G 1/2 OR 23 1INCH IS ALL YA NEED...