Tweetdamn...i wouldnt use it...i'd trash it. that blows
TweetA buddy of mine is using deca and the rubber stopper came off the vial for some reason?? I told him to not use that anymore cus it may be contaminated?? Is this correct? for some reason he says when he was injected air from the syringe into the vial...the rubber stopper came off?? I think he might of took that metal surrounding the outside of the vial off for some reason and thats the problem? So should he just cuck out that vial or is it still good to use?
Tweetdamn...i wouldnt use it...i'd trash it. that blows
HE WHO MAKES A BEAST OF HIMSELF, GET'S RID OF THE PAIN OF BEING A MAN!!
https://www.infinitymuscle.com/forum.php
"Actually for once your actually starting sound quite logical!"-djdiggler 07/10/2007
I LOVE BOOBOOKITTY...
Tweetwhy would you trash it? because it could be contaminated or what? even if it was for only off for a split second?
Thanks for the reply dav
Tweetyou always could try and run it through a whatman filter into a fresh sealed vial. then heat it up in a almost boiling water pan for about 15 min, don't let the water boil though.
Its really not worth the risk though but if he's destitute I'd do the above
Tweetexactly becouse of possiblilty of contamination...aint worth the risk for me...whats a split secound...i'd be trying to think if i had something on my hand that tuched the inside of the stopper or not...fuk it...aint worth the brain damage to me...toss it
HE WHO MAKES A BEAST OF HIMSELF, GET'S RID OF THE PAIN OF BEING A MAN!!
https://www.infinitymuscle.com/forum.php
"Actually for once your actually starting sound quite logical!"-djdiggler 07/10/2007
I LOVE BOOBOOKITTY...
TweetI don't know it is kinda risky but this happened to a friend of mine (kinda). He pushed too much air in a vial and the bottom of the vial popped off - he was holding it upside down. He managed to pull the remaining compound out and transfer it to another vial.
My friend went ahead and used it - had no problems either but if you see dust in it, thats not even a decision.
TweetHE CAN ORDER SOME RUBBER STOPPERS FROM RESEARCHLABSUPPLY.COM THAT YOU DONT HAVE TO HAVE CRIMPERS TO PUT IT ON. THEY ARE CHEAP TOO
O2
Tweetif he didnt touch the oil just wash the stopper with alcohol and stick it back on. Then each time you draw remove it and suck out your amount then stick it back on. The juice has BA in it so just exposing it to the atmosphere will do nothing. If you want to be really safe just get a syringe filter and a presealed vial and flush the juice through the filter into the new bottle.
TweetHad that happen with some Sta!!!on Lab stuff.
Still used it - just drew it up from the open vial, put cap back on when I was done. Never had a problem.
Thouhg I DO NOT recommend it!
As much as it bothered me by the quality of the packaging it was some strong stuff.
Sal
Tweetits not contaiminated if air hits it. its just like using one giant amp. the ba will prevent infection.
when you crack the top off of an amp and draw out of it the test is open to air. same process just make sure your not dropping the stopper on the ground or getting it dirty. i would just pre-load the rest of the bottle into pins.
Badasz1@Hushmail.com