Note **
I edited my earlier post.
For a 10G kit (jesus, why state it in MG's...) only 12 ML's of dissolving solution is required.
Note **
I edited my earlier post.
For a 10G kit (jesus, why state it in MG's...) only 12 ML's of dissolving solution is required.
It needs at least 10ml. That is if 1g of tren you can get to dissolve in 1ml solvent while surrounded by the glue and binders, which may absorb some. I think it would have to be at least 15ml for 10grams worth to get it all.
Unless, its not supposed to be completely dissolved before adding the oil. The I think it is feasable to say 10ml solvent would do it. I have no idea what kit you have though. Most that I have seen/used are 5ml solvent mixture per 2g hormone.
Every 2g kit I ever recieved had 5 ml's of solution. All kits were the same as they increased in size. I have a 10g kit now and there is 22 ml's in there. I use Animal kits. I have found that less solvient does not really make that clean of a final product.
I was gonna say about 10cc's BA for 10,000 mgs of fina
I don't know about heavy duty, but I usually do 10-20 grams at a time. But then I haven't been off fina since june. Just cause your doing a 10g kit doesnt mean your selling it.Quote:
Originally posted by manny78
so wanna do Fina for 133 days at 75 mg ED ? 4 Months ? Really ? No sourcing sure ?
I know but anyway I've seen this enough in the past to know that in most cases the person will get PMs from dumb newbies asking if he's preparing so much Fina to "share"....:allcoholiQuote:
Originally posted by fireman
I don't know about heavy duty, but I usually do 10-20 grams at a time. But then I haven't been off fina since june. Just cause your doing a 10g kit doesnt mean your selling it.
my point is I want to know for sure what the deal is.....look how many different opinions there are on how much solution is needed to convert the pellets.....all I want is to know for sure what is needed ml wise of solution......and so far there isn't really a consensus for an answer.
Well I don't think there is a concesus on a set way. there are too many suppliers of conversion kits and they all use diff amounts. It also depends on how you convert. If going the traditional dissolve, add oil, seperate, filter. You are going to need at least 12 probably 15 ml. If doing the white crystal or acetone method, You will only need enough to suspend the tren in the oil and keep the product sterile, and as billy said it takes about 1/5 -1/10 the percent if you seperate the binders and work with pure tren powder.
Actually, when I said 1/5-2/5's I was reffering to kits that used 5ml per 2 grams. I think the minimal you will get is 1ml per 1g. Maybe less since the oil helps out though, but not that much less.
i got 10cc's for my 8g kit...